How to install the stainless steel mixing tank

- Sep 04, 2020-

Description: Before using the mixing tank, the reservoir must be cleaned with fresh hot water and then sterilized with steam. The material filling liquid enters the tank through the material pipe on the fixed cylinder head, or the cylinder cover is opened to pour and output material it should not be packed too full to avoid splashing when the material is stirred, resulting in unhealthy environment or loss.


Heating method: If the equipment is equipped with a temperature device, first adjust the thermometer to the required temperature, and then supply the power. After use, the power should be cut off, and then the power of the stirrer should be turned off.


Cleaning: After the processing is finished, the remaining materials in the tank should be exhausted. Rinse with warm water as soon as possible, brush off the sticky materials, and then wash the inner wall of the container with alkaline water at 10~50 degrees Celsius, and rinse with clean water. When it is used again next time, Sterilize with hot water or steam for 3 to 4 minutes.


Maintenance: Always pay attention to the working conditions of the sub-equipment and the reducer. When the reducer has insufficient lubricating oil, it should be replenished once every six months and pay attention to the level of the thermal oil. When the equipment is not in use, the interlayer must be cleaned with warm water to avoid salt water. Corrosion, often scrub the cylinder, keep the appearance clean, the inner liner bright, to achieve the purpose of durability. After use, the power supply should be cut off first, and then cooling water should be added to protect the electric heating tube or heating rod to extend the service life.